Non-Contact Voltage Tester Pen, 50 to 1000V AC
NCVT1P
- Voltage Tester provides non-contact detection of voltage in cables, cords, circuit breakers, lighting fixtures, switches, non-tamper-resistant outlets and wires
- Volt Pen with high intensity, bright green LED indicates the tester is powered ON
- When a voltage is detected, a high intensity, bright red LED illuminates and an audible tone will sound
- 50 to 1000 VAC power operating range allows for broad applications
- Auto power-off feature conserves and extends battery life
- CAT IV 1000 V safety rating
- Lightweight compact design with a convenient clip to fit securely in your pocket
- Product not recommended for testing tamper-resistant outlets; use Cat. Nos. NCVT-2P or NCVT-3P in low voltage mode
- Includes instructions and 2 x AAA (1.5 volt) batteries
- 6.6-foot (2 m) drop protection
Klein Tools Non-Contact Voltage Tester detects standard voltage in cables, cords, circuit breakers, lighting fixtures, switches, non-tamper-resistant outlets and wires. A bright green LED indicates the tester is powered ON. It changes to red and an audible tone sounds when a voltage is detected.
Specifications
Type:
Voltage Tester Pen
Application:
Non-Contact Detection and Testing of AC Voltage; Not Recommended for Tamper-Resistant Outlets
Special Features:
Green LED Indicates Power-On; Red LED Indicates Voltage Detected with Audible Beeps
Material:
Polymer Body and Electronic Components
Drop Protection:
9.8' (3 m)
Voltage:
50-1000V AC
Frequency:
50-500 Hz
Pollution Degree:
2
Standard:
CAT IV 1000V
Included:
NCVT; Instructions; 2 x AAA 1.5V Batteries
Batteries:
2 x AAA
Overall Length:
5.5'' (14 cm)
Overall Height:
0.72” (1.8 cm)
Overall Width:
1'' (2.5 cm)
Weight:
0.8 oz (23 g)
UPC:
092644693700
Warnings
- Read, understand and follow all warnings, cautions, safety information and instructions in this manual before operating or servicing this tester. Failure to follow instructions could result in death or serious injury.
- Never assume that neutral or ground wires are not live. Neutrals in multi-wire branch circuits may be energised when disconnected and must be retested before handling.
